Hi,

I have a freescale IMX35PDK (3 stack) and want to get a bmp showing as a splash screen, but am not having any luck. (Just getting a white screen, although the backlight comes on). All hardware is as-original, using the CLAA 800x480 LCD.

Has anyone had success getting something showing on the screen with the mx35 pdk? (or any other platform I can use as a reference).

To test, I’m simply using the “bmp” command with a small 100x100 test picture. No errors are reported, but the screen never changes.

From the barebox prompt if do “devinfo fb0” I get some info, but the enable is 0.

If  I do fb0.enable=1 it doesn’t make a difference.

Also:

- The fb works fine once booted into linux.

- Start-up messages indicate that the driver and device is recognized:

Any ideas?

Cheers

Marc

PS. Snip of startup messages: (shows the driver/device is being loaded)

barebox 2010.03.0-00100-gf4a5a39-dirty (Mar 31 2010 - 18:32:31)                

Board: Freescale MX35 3Stack                                                   

NAND device: Manufacturer ID: 0xec, Chip ID: 0xd5 (Samsung NAND 2GiB 3,3V 8-bit)

Bad block table found at page 1048448, version 0x01                            

Bad block table found at page 1048320, version 0x01                            

cfi_probe: cfi_flash base: 0xa0000000 size: 0x04000000                         

cfi_protect: protect 0xa0040000 (size 524288)                                  

imx-ipu-fb@imx-ipu-fb0: i.MX Framebuffer driver                                

mc13892@mc138920: revision: 0x41d0