mail archive of the barebox mailing list
 help / color / mirror / Atom feed
From: "Eric Bénard" <eric@eukrea.com>
To: barebox@lists.infradead.org
Subject: [PATCH 6/7] sama5d3xek: add NOR CFI support
Date: Sat,  7 Dec 2013 10:36:59 +0100	[thread overview]
Message-ID: <1386409020-11914-6-git-send-email-eric@eukrea.com> (raw)
In-Reply-To: <1386409020-11914-1-git-send-email-eric@eukrea.com>

log is now :
cfi_flash cfi_flash0: found cfi flash at 10000000, size 16777216

Signed-off-by: Eric Bénard <eric@eukrea.com>
---
 arch/arm/boards/sama5d3xek/init.c | 35 +++++++++++++++++++++++++++++++++++
 1 file changed, 35 insertions(+)

diff --git a/arch/arm/boards/sama5d3xek/init.c b/arch/arm/boards/sama5d3xek/init.c
index ff62550..f7dfea0 100644
--- a/arch/arm/boards/sama5d3xek/init.c
+++ b/arch/arm/boards/sama5d3xek/init.c
@@ -118,6 +118,40 @@ static void ek_add_device_nand(void)
 static void ek_add_device_nand(void) {}
 #endif
 
+#if defined(CONFIG_DRIVER_CFI)
+static struct sama5_smc_config __initdata cm_nor_smc_config = {
+	.ncs_read_setup		= 10,
+	.nrd_setup		= 10,
+	.ncs_write_setup	= 10,
+	.nwe_setup		= 10,
+
+	.ncs_read_pulse		= 11,
+	.nrd_pulse		= 11,
+	.ncs_write_pulse	= 11,
+	.nwe_pulse		= 11,
+
+	.read_cycle		= 22,
+	.write_cycle		= 22,
+
+	.mode			= AT91_SMC_READMODE | AT91_SMC_WRITEMODE | AT91_SMC_DBW_16,
+	.tdf_cycles		= 6,
+};
+
+static void ek_add_device_norcfi(void)
+{
+	struct clk *clk = clk_get(NULL, "smc_clk");
+
+	clk_enable(clk);
+
+	/* configure chip-select 0 (NOR) */
+	sama5_smc_configure(0, 0, &cm_nor_smc_config);
+
+	add_cfi_flash_device(0, AT91_CHIPSELECT_0, 256 * 1024 * 1024, 0);
+}
+#else
+static void ek_add_device_norcfi(void) {}
+#endif
+
 #if defined(CONFIG_DRIVER_NET_MACB)
 static struct macb_platform_data gmac_pdata = {
 	.phy_interface = PHY_INTERFACE_MODE_RGMII,
@@ -413,6 +447,7 @@ static int at91sama5d3xek_devices_init(void)
 	ek_add_device_w1();
 	ek_add_device_hdmi();
 	ek_add_device_nand();
+	ek_add_device_norcfi();
 	ek_add_led();
 	ek_add_device_eth();
 	ek_add_device_spi();
-- 
1.8.3.1


_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox

  parent reply	other threads:[~2013-12-07  9:37 UTC|newest]

Thread overview: 27+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2013-12-07  9:36 [PATCH 1/7] atmel_nand: check gpio validity before using it Eric Bénard
2013-12-07  9:36 ` [PATCH 2/7] at91: introduce sama5d3's SMC support Eric Bénard
2013-12-09 13:27   ` Jean-Christophe PLAGNIOL-VILLARD
2013-12-12  8:51     ` Sascha Hauer
2013-12-12  9:53       ` Eric Bénard
2013-12-07  9:36 ` [PATCH 3/7] at91: sama5d3: use the sama5 smc instead of the sam9 one Eric Bénard
2013-12-09 13:28   ` Jean-Christophe PLAGNIOL-VILLARD
2013-12-07  9:36 ` [PATCH 4/7] sama5d3xek: update nand timings Eric Bénard
2013-12-07  9:36 ` [PATCH 5/7] atmel_nand: make chip_delay configurable Eric Bénard
2013-12-09 13:30   ` Jean-Christophe PLAGNIOL-VILLARD
2013-12-09 14:54     ` Eric Bénard
2013-12-09 16:32       ` Jean-Christophe PLAGNIOL-VILLARD
2013-12-09 16:57         ` Eric Bénard
2013-12-09 17:15         ` Eric Bénard
2013-12-10  7:25           ` Sascha Hauer
2013-12-07  9:36 ` Eric Bénard [this message]
2013-12-09 13:37   ` [PATCH 6/7] sama5d3xek: add NOR CFI support Jean-Christophe PLAGNIOL-VILLARD
2013-12-12  8:57     ` Sascha Hauer
2013-12-12  9:52       ` Eric Bénard
2013-12-07  9:37 ` [PATCH 7/7] samsa5d3xek: update defconfig Eric Bénard
2013-12-09 13:31   ` Jean-Christophe PLAGNIOL-VILLARD
2013-12-09 14:53     ` Eric Bénard
2013-12-09 16:33       ` Jean-Christophe PLAGNIOL-VILLARD
2013-12-09 16:48       ` Alexander Aring
2013-12-09  8:36 ` [PATCH 1/7] atmel_nand: check gpio validity before using it Sascha Hauer
2013-12-09 13:31   ` Jean-Christophe PLAGNIOL-VILLARD
2013-12-09 13:34 ` Jean-Christophe PLAGNIOL-VILLARD

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1386409020-11914-6-git-send-email-eric@eukrea.com \
    --to=eric@eukrea.com \
    --cc=barebox@lists.infradead.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox