From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from metis.ext.pengutronix.de ([2001:6f8:1178:4:290:27ff:fe1d:cc33]) by canuck.infradead.org with esmtps (Exim 4.76 #1 (Red Hat Linux)) id 1QYYXe-0000wL-2L for barebox@lists.infradead.org; Mon, 20 Jun 2011 07:05:03 +0000 Date: Mon, 20 Jun 2011 09:04:58 +0200 From: Sascha Hauer Message-ID: <20110620070458.GN23771@pengutronix.de> References: MIME-Version: 1.0 Content-Disposition: inline In-Reply-To: List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: barebox-bounces@lists.infradead.org Errors-To: barebox-bounces+u.kleine-koenig=pengutronix.de@lists.infradead.org Subject: Re: booting pandaboard rev A2 problems To: Belisko Marek Cc: barebox@lists.infradead.org Hi Marek, On Fri, Jun 17, 2011 at 09:26:46PM +0200, Belisko Marek wrote: > Hi, > > I'm trying to boot barebox on Panda rev. A2. Hm, I don't know the revision of our panda board. I'll have a look later, it may be different. > > I make panda_xload_defconfig compile and put to FAT SD card partition > ranamed barebox.bin to u-boot.bin (MLO reads u-boot.bin by default). I'm a bit confused. The binary resulting from xload_defconfig is supposed to replace MLO. There are two panda defconfig in the tree, one for xloader replacement and one regular full blown config. > > Barebox start but after printing revision number is stuck. I add some > printks and > seems it hang in omap_hsmmc_probe funtion after mci_register(&hsmmc->mci) call. > > I try with 2 SD cards and non of them is working. > > Also try to load to flash partition only barebox.bin.itf + barebox.bin > but this setup also > doesn't work. AFAIU itf add some data before barebox to be possible to > boot directly without > x-loader. When run_shell is called barebox.bin should be copied do > DDRAM and run. Ok, let's try to sort things a bit. does panda_xload_defconfig barebox.bin.itf copied as MLO to the SD card produce any output? Does panda_defconfig copied as u-boot.bin to the SD card work or does it behave like you described above? Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@lists.infradead.org http://lists.infradead.org/mailman/listinfo/barebox