From: Sascha Hauer <s.hauer@pengutronix.de>
To: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: barebox@lists.infradead.org
Subject: Re: [PATCH 1/4] macb: use dev_xx message
Date: Fri, 8 Feb 2013 09:36:49 +0100 [thread overview]
Message-ID: <20130208083649.GA25672@pengutronix.de> (raw)
In-Reply-To: <1360059306-31118-1-git-send-email-plagnioj@jcrosoft.com>
On Tue, Feb 05, 2013 at 11:15:03AM +0100, Jean-Christophe PLAGNIOL-VILLARD wrote:
> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
> ---
> drivers/net/macb.c | 34 +++++++++++++++++++---------------
> 1 file changed, 19 insertions(+), 15 deletions(-)
>
> diff --git a/drivers/net/macb.c b/drivers/net/macb.c
> index 18ac3f8..15b1e93 100644
> --- a/drivers/net/macb.c
> +++ b/drivers/net/macb.c
> @@ -96,7 +96,7 @@ struct macb_device {
>
> int phy_addr;
>
> - const struct device *dev;
> + const struct device_d *dev;
> struct eth_device netdev;
>
> phy_interface_t interface;
> @@ -112,7 +112,7 @@ static int macb_send(struct eth_device *edev, void *packet,
> struct macb_device *macb = edev->priv;
> unsigned long ctrl;
>
> - debug("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> ctrl = length & TXBUF_FRMLEN_MASK;
> ctrl |= TXBUF_FRAME_END | TXBUF_WRAP;
> @@ -123,15 +123,15 @@ static int macb_send(struct eth_device *edev, void *packet,
> dma_flush_range((ulong) packet, (ulong)packet + length);
> macb_writel(macb, NCR, MACB_BIT(TE) | MACB_BIT(RE) | MACB_BIT(TSTART));
>
> - wait_on_timeout(100 * MSECOND,
> + ret = wait_on_timeout(100 * MSECOND,
> !(macb->tx_ring[0].ctrl & TXBUF_USED));
This hunk belongs to patch 3/4 and breaks compiling here. Fixed that up.
Sascha
>
> ctrl = macb->tx_ring[0].ctrl;
>
> if (ctrl & TXBUF_UNDERRUN)
> - printf("TX underrun\n");
> + dev_err(macb->dev, "TX underrun\n");
> if (ctrl & TXBUF_EXHAUSTED)
> - printf("TX buffers exhausted in mid frame\n");
> + dev_err(macb->dev, "TX buffers exhausted in mid frame\n");
>
> /* No one cares anyway */
> return 0;
> @@ -142,7 +142,7 @@ static void reclaim_rx_buffers(struct macb_device *macb,
> {
> unsigned int i;
>
> - debug("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> i = macb->rx_tail;
> while (i > new_tail) {
> @@ -170,7 +170,7 @@ static int macb_recv(struct eth_device *edev)
> int wrapped = 0;
> u32 status;
>
> -// printf("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> for (;;) {
> if (!(macb->rx_ring[rx_tail].addr & RXADDR_USED))
> @@ -235,7 +235,7 @@ static int macb_open(struct eth_device *edev)
> {
> struct macb_device *macb = edev->priv;
>
> - debug("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> /* Obtain the PHY's address/id */
> return phy_device_connect(edev, &macb->miibus, macb->phy_addr,
> @@ -249,7 +249,7 @@ static int macb_init(struct eth_device *edev)
> unsigned long paddr, val = 0;
> int i;
>
> - debug("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> /*
> * macb_halt should have been called at some point before now,
> @@ -318,7 +318,7 @@ static int macb_phy_read(struct mii_bus *bus, int addr, int reg)
> int value;
> uint64_t start;
>
> - debug("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> netctl = macb_readl(macb, NCR);
> netctl |= MACB_BIT(MPE);
> @@ -335,7 +335,7 @@ static int macb_phy_read(struct mii_bus *bus, int addr, int reg)
> do {
> netstat = macb_readl(macb, NSR);
> if (is_timeout(start, SECOND)) {
> - printf("phy read timed out\n");
> + dev_err(macb->dev, "phy read timed out\n");
> return -1;
> }
> } while (!(netstat & MACB_BIT(IDLE)));
> @@ -357,7 +357,7 @@ static int macb_phy_write(struct mii_bus *bus, int addr, int reg, u16 value)
> unsigned long netstat;
> unsigned long frame;
>
> - debug("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> netctl = macb_readl(macb, NCR);
> netctl |= MACB_BIT(MPE);
> @@ -384,7 +384,9 @@ static int macb_phy_write(struct mii_bus *bus, int addr, int reg, u16 value)
>
> static int macb_get_ethaddr(struct eth_device *edev, unsigned char *adr)
> {
> - debug("%s\n", __func__);
> + struct macb_device *macb = edev->priv;
> +
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> return -1;
> }
> @@ -393,7 +395,7 @@ static int macb_set_ethaddr(struct eth_device *edev, unsigned char *adr)
> {
> struct macb_device *macb = edev->priv;
>
> - debug("%s\n", __func__);
> + dev_dbg(macb->dev, "%s\n", __func__);
>
> /* set hardware address */
> macb_writel(macb, SA1B, adr[0] | adr[1] << 8 | adr[2] << 16 | adr[3] << 24);
> @@ -412,7 +414,7 @@ static int macb_probe(struct device_d *dev)
> struct clk *pclk;
>
> if (!dev->platform_data) {
> - printf("macb: no platform_data\n");
> + dev_err(dev, "macb: no platform_data\n");
> return -ENODEV;
> }
> pdata = dev->platform_data;
> @@ -421,6 +423,8 @@ static int macb_probe(struct device_d *dev)
> edev->priv = (struct macb_device *)(edev + 1);
> macb = edev->priv;
>
> + macb->dev = dev;
> +
> edev->init = macb_init;
> edev->open = macb_open;
> edev->send = macb_send;
> --
> 1.7.10.4
>
>
> _______________________________________________
> barebox mailing list
> barebox@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/barebox
>
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox
prev parent reply other threads:[~2013-02-08 8:36 UTC|newest]
Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-02-05 10:12 [PATCH 0/4] macb: more fixes Jean-Christophe PLAGNIOL-VILLARD
2013-02-05 10:15 ` [PATCH 1/4] macb: use dev_xx message Jean-Christophe PLAGNIOL-VILLARD
2013-02-05 10:15 ` [PATCH 2/4] macb: register the phy after the macb is init Jean-Christophe PLAGNIOL-VILLARD
2013-02-06 19:35 ` Sascha Hauer
2013-02-06 19:37 ` Sascha Hauer
2013-02-06 20:16 ` Jean-Christophe PLAGNIOL-VILLARD
2013-02-06 20:32 ` Sascha Hauer
2013-02-06 20:34 ` Jean-Christophe PLAGNIOL-VILLARD
2013-02-06 20:39 ` Sascha Hauer
2013-02-05 10:15 ` [PATCH 3/4] macb: report timeout on send Jean-Christophe PLAGNIOL-VILLARD
2013-02-05 10:15 ` [PATCH 4/4] macb: drop non used define Jean-Christophe PLAGNIOL-VILLARD
2013-02-08 8:36 ` Sascha Hauer [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20130208083649.GA25672@pengutronix.de \
--to=s.hauer@pengutronix.de \
--cc=barebox@lists.infradead.org \
--cc=plagnioj@jcrosoft.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox