From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from metis.ext.pengutronix.de ([2001:6f8:1178:4:290:27ff:fe1d:cc33]) by bombadil.infradead.org with esmtps (Exim 4.80.1 #2 (Red Hat Linux)) id 1WctgZ-0002rP-MZ for barebox@lists.infradead.org; Wed, 23 Apr 2014 09:41:48 +0000 Date: Wed, 23 Apr 2014 11:41:25 +0200 From: Sascha Hauer Message-ID: <20140423094125.GI5858@pengutronix.de> References: <1397395668-9325-1-git-send-email-dev@lynxeye.de> MIME-Version: 1.0 Content-Disposition: inline In-Reply-To: <1397395668-9325-1-git-send-email-dev@lynxeye.de> List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: "barebox" Errors-To: barebox-bounces+u.kleine-koenig=pengutronix.de@lists.infradead.org Subject: Re: [PATCH 00/18] Tegra 3 support To: Lucas Stach Cc: barebox@lists.infradead.org On Sun, Apr 13, 2014 at 03:27:30PM +0200, Lucas Stach wrote: > Ok, this one took me a little longer than I would > have wished for, but now it's good enough to post. > > This series adds support for the Tegra 3 line of > SoCs. This includes a clock driver that sets up the > PLLs and peripheral clocks and a pinctrl driver to > bring the external muxing into a sane state. > > There is still a lot to do here, but with this > series barebox starts up on an NVidia Beaver board > and the eMMC is usable. > > Next step would be to integrate BCT writing into > the Tegra image process so barebox is able to write > itself to MMC as a bootable image. > > Lucas Stach (18): > gpio: tegra: remove dead code > mmc: tegra: fix typo > tegra: disable more lowlevel unsafe switch optimizations > tegra: source MSELECT clock from CLK_M > tegra: add Tegra3 kconfig symbol > tegra: add Tegra3 ramsize detection > tegra: add Tegra3 mem initcall > tegra: recognize T30 in debug UART code > dt-bindings: add pinctrl-tegra.h > pinctrl: tegra: add Tegra3 driver > dt-bindings: add tegra30-car.h > clk: tegra: consider new T30 clock registers > clk: tegra: add Tegra3 driver > gpio: tegra: add Tegra3 setup > ARM: tegra: add basic Tegra3 DT > ARM: tegra: add NVidia Beaver board support > ARM: dts: tegra: add full Beaver pinmux > defconfig: tegra: add some useful options Applied, thanks Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@lists.infradead.org http://lists.infradead.org/mailman/listinfo/barebox