On Wed, Oct 21, 2020 at 12:05:48PM +0200, Sascha Hauer wrote: > On Tue, Oct 20, 2020 at 01:15:37PM +0200, Uwe Kleine-König wrote: > > Instead of just ignoring errors related to regulator getting error out. > > In case there is no regulator in the device tree, regulator_get() returns > > the dummy regulator and not an error code, so the change is right for > > this situation, too. > > > > Signed-off-by: Uwe Kleine-König > > --- > > drivers/usb/imx/chipidea-imx.c | 7 +++++-- > > 1 file changed, 5 insertions(+), 2 deletions(-) > > > > diff --git a/drivers/usb/imx/chipidea-imx.c b/drivers/usb/imx/chipidea-imx.c > > index 786beede6d89..dd0e3c1a2a58 100644 > > --- a/drivers/usb/imx/chipidea-imx.c > > +++ b/drivers/usb/imx/chipidea-imx.c > > @@ -267,8 +267,11 @@ static int imx_chipidea_probe(struct device_d *dev) > > } > > > > ci->vbus = regulator_get(dev, "vbus"); > > - if (IS_ERR(ci->vbus)) > > - ci->vbus = NULL; > > + if (IS_ERR(ci->vbus)) { > > + ret = ERR_PTR(ci->vbus); > > + dev_err(dev, "Cannot get vbus regulator: %s\n", strerror(-ret)); > > + return ret; > > + } > > Ok, as Marco noted we had regressions in similar cases where we didn't > have a driver for the regulator, but knew that it was default enabled. > Therefore I am dropping this patch. So you prefer "fails on some boards with a missleading (or at least little helpful) error message" over "fails on some (other) boards with an obvious error indication"? I think I would have decided this differently. And IMHO then this should at least result in a runtime warning instead of being silently optimistic. Best regards Uwe -- Pengutronix e.K. | Uwe Kleine-König | Industrial Linux Solutions | https://www.pengutronix.de/ |