From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from moutng.kundenserver.de ([212.227.126.186]) by merlin.infradead.org with esmtps (Exim 4.76 #1 (Red Hat Linux)) id 1TVMiH-00031o-4E for barebox@lists.infradead.org; Mon, 05 Nov 2012 13:27:37 +0000 Message-ID: <5097BEBE.5040706@cmotion.eu> Date: Mon, 05 Nov 2012 14:27:26 +0100 From: Christian Kapeller MIME-Version: 1.0 References: <50979E1A.2000707@cmotion.eu> <20121105125258.GV1641@pengutronix.de> In-Reply-To: <20121105125258.GV1641@pengutronix.de> List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: barebox-bounces@lists.infradead.org Errors-To: barebox-bounces+u.kleine-koenig=pengutronix.de@lists.infradead.org Subject: Re: TX53: Not Bootable from next tree To: Sascha Hauer Cc: barebox@lists.infradead.org >> I've just flashed barebox from the next tree onto a TX53-8030 module, >> and have to report, that the board won't boot. >> >> Currently I've tried to run it with MMU off and setting the text-base >> to 0x71000000, with no positive results. >> >> I'll do further investigation, but meanwhile does anyone have barebox >> running on a TX53 board? > > I just tested that it works for me as second stage. I can't test 1st > stage atm as I currently have no physical access to the board. Until now I've used bb in a 2nd stage configuration on top of the supplied Redboot, and it worked without any problem. Additionally I had CONFIG_MACH_DO_LOW_LEVEL_INIT disabled which skips another pll setup step, that was already done by Redboot. > Some guesses: Have you checked the correct the correct board revision in > the config? It's the default, so I assume it's correct. Yes, I did check for the correct board revision, and am using the correct one: CONFIG_TX53_REV_XX30=y > Are you using the barebox-flash-image link or barebox.bin? You have to > use the former because it's a compressed image. I've noticed, that the link target changes depending on build configuration. So I've flashed the file pointed to by barebox-flash-image. > You might want to disable compressed image support in > General settings -> > memory layout -> > [ ] pre-bootoloader image Just tried that, but without changed result. Currently I am trying to get my PEEDI JTAG probe working with the board, but until then I stay in the dark. Cheers, Christian _______________________________________________ barebox mailing list barebox@lists.infradead.org http://lists.infradead.org/mailman/listinfo/barebox