On Mon, Oct 17, 2011 at 06:03:56PM +0200, Kamel BOUHARA wrote:
> Hi all,
>
> Im working on my own imx27 designed board and wanted to try barebox on
> it.Actually I'm trying it with the phytec board config and it seems to work
> fine booting on my nfs kernel and rootfs.
> But when Im trying to boot from my 128MiB NAND memory then it doesn't work
> and there is no decompression stage from the kernel.
> Here is what Im getting :
>
> Board: Phytec phyCard-i.MX27
> registered netconsole as cs1
> cfi_probe: cfi_flash base: 0xc0000000 size: 0x02000000
> NAND device: Manufacturer ID: 0x2c, Chip ID: 0xac (Micron NAND 512MiB 1,8V
> 8-bit)
> Bad block table found at page 262080, version 0x01
> Bad block table found at page 262016, version 0x01
> Before PHY reset
> After PHY reset
> ULPI Vendor ID 0xffffff92 Product ID 0xffffff92
> No ISP1504 found
> ehci@ehci0: USB EHCI 1.00
> ULPI Vendor ID 0xffffff92 Product ID 0xffffff92
> No ISP1504 found
> ehci@ehci1: USB EHCI 1.00
> Malloc space: 0xa7a00000 -> 0xa7f00000 (size 5 MB)
> Stack space : 0xa79f8000 -> 0xa7a00000 (size 32 kB)
> running /env/bin/init...
>
> Hit any key to stop autoboot: 1
> booting kernel of type uImage from /dev/
nand0.kernel.bb
> barebox:/ bootu /dev/
nand0.kernel.bb