From: Kamel BOUHARA <k.bouhara@gmail.com>
To: barebox@lists.infradead.org
Subject: Network Issue with Mini2440
Date: Fri, 23 Mar 2012 01:53:33 +0100 [thread overview]
Message-ID: <CAM9uW_6qLEEmNFtTxLxNHx86zzFnHRfxB+1pm+VfRfjf4FrfBg@mail.gmail.com> (raw)
[-- Attachment #1.1: Type: text/plain, Size: 3902 bytes --]
Hello,
I'm trying to port the last release of barebox to my sbc2440-III board with
the base config. of a mini2440 but unfortunately I'm facing a network issue
when trying to boot from nfs or to load files with tftp.
After checking all the parameters (pll, ram init etc.) I figured out that
the chip select and interrupt pinout were not good and I changed them to
fit with my board schematic.
So I have a well boot on barebox everything seems to work as you can see
here :
barebox 2012.03.0-00113-g881d9e9-dirty (Mar 23 2012 - 00:45:52)
> Board: Mini 2440
registered netconsole as cs1
NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V
> 8-bit)
Bad block table found at page 65472, version 0x01
Bad block table found at page 65408, version 0x01
dm9000@dm90000: Found DM9000A at i/o: 0x18000300
refclk: 12000 kHz
mpll: 405000 kHz
upll: 48000 kHz
fclk: 405000 kHz
hclk: 101250 kHz
pclk: 50625 kHz
SDRAM1: CL2@101MHz
Malloc space: 0x33a00000 -> 0x33dfffff (size 4 MB)
Stack space : 0x339f8000 -> 0x33a00000 (size 32 kB)
running /env/bin/init...
But, when I try to ping or boot from nfs/tftp, the phy isn't receiving any
packet from host :
Hit any key to stop autoboot: 0
warning: No MAC address set. Using random address F6:48:4B:C2:51:44
phy0: Link is up - 100/Full
T T T T T T T T T T T T T T T T T T T T T T
I'm sure the host is well configured because I usually have to work with
other boards using nfs and tftp.
Here is more complete log of the packets transaction I hope it could help :
barebox 2012.03.0-00113-g881d9e9-dirty (Mar 23 2012 - 00:45:52)
> Board: Mini 2440
registered netconsole as cs1
NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V
> 8-bit)
Bad block table found at page 65472, version 0x01
Bad block table found at page 65408, version 0x01
dm9000@dm90000: dm9k_reset
dm9000@dm90000: dm9000 revision 0x19
dm9000@dm90000: Found DM9000A at i/o: 0x18000300
dm9000@dm90000: 16 bit data bus
dm9000@dm90000: phy_write(reg:0, value:32768)
dm9000@dm90000: phy_read(4): 481
dm9000@dm90000: phy_write(reg:4, value:481)
dm9000@dm90000: phy_write(reg:0, value:4608)
refclk: 12000 kHz
mpll: 405000 kHz
upll: 48000 kHz
fclk: 405000 kHz
hclk: 101250 kHz
pclk: 50625 kHz
SDRAM1: CL2@101MHz
Malloc space: 0x33a00000 -> 0x33dfffff (size 4 MB)
Stack space : 0x339f8000 -> 0x33a00000 (size 32 kB)
running /env/bin/init...
> Hit any key to stop autoboot: 1
warning: No MAC address set. Using random address 36:CF:EC:0D:18:BC
dm9000@dm90000: phy_read(1): 30825
dm9000@dm90000: phy_read(1): 30829
dm9000@dm90000: phy_read(1): 30829
dm9000@dm90000: phy_read(0): 12544
dm9000@dm90000: phy_read(5): 50657
phy0: Link is up - 100/Full
dm9000@dm90000: dm9k_eth_send: 42 bytes
dm9000@dm90000: transmit done
dm9000@dm90000: Packet present
dm9000@dm90000: dm9k_validate_entry packet status 01
dm9000@dm90000: rx Late Collision Seen error
dm9000@dm90000: rx length too big
dm9000@dm90000: dm9k_reset
T dm9000@dm90000: dm9k_eth_send: 42 bytes
dm9000@dm90000: transmit done
dm9000@dm90000: Packet present
dm9000@dm90000: dm9k_validate_entry packet status 01
dm9000@dm90000: rx fifo overflow error
dm9000@dm90000: rx crc error
dm9000@dm90000: Discarding packet
dm9000@dm90000: dm9k_validate_entry packet status 00
T dm9000@dm90000: dm9k_eth_send: 42 bytes
dm9000@dm90000: transmit done
dm9000@dm90000: Packet present
dm9000@dm90000: dm9k_validate_entry packet status 00
T dm9000@dm90000: dm9k_eth_send: 42 bytes
dm9000@dm90000: transmit done
dm9000@dm90000: Packet present
dm9000@dm90000: dm9k_validate_entry packet status 00
NFS failed: Interrupted system call
Any help is welcome for sure.
Regards.
--
_______________________________
*Kamel BOUHARA*
62 Bis Rue Carnot
60610 Lacroix Saint-Ouen
Tel : +33617832904
[-- Attachment #1.2: Type: text/html, Size: 22339 bytes --]
[-- Attachment #2: Type: text/plain, Size: 149 bytes --]
_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox
next reply other threads:[~2012-03-23 0:53 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-03-23 0:53 Kamel BOUHARA [this message]
2012-03-23 8:22 ` Juergen Beisert
2012-03-23 18:17 ` Fwd: " Kamel BOUHARA
2012-03-24 7:35 ` Kamel BOUHARA
2012-03-24 8:50 ` Juergen Beisert
2012-03-25 5:55 ` Jean-Christophe PLAGNIOL-VILLARD
2012-03-24 8:50 ` Fwd: " Juergen Beisert
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=CAM9uW_6qLEEmNFtTxLxNHx86zzFnHRfxB+1pm+VfRfjf4FrfBg@mail.gmail.com \
--to=k.bouhara@gmail.com \
--cc=barebox@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox