[PATCH 00/18] fs: add symlink and readlink support
2012-08-24 4:50 UTC (4+ messages)
` [PATCH 01/18] fs: add "
` [PATCH 02/18] fs: rename stat to lstat as we implement lstat
` [PATCH 05/18] fs: open: add symlink support
[PATCH] commands/digest: don't print checksum for non-existing files
2012-08-23 19:21 UTC
Booting PhyTec PCM043/IMX35 from USB/SD-Card
2012-08-23 17:59 UTC (7+ messages)
[PATCH 0/3] Freescale I2C driver
2012-08-22 15:08 UTC (4+ messages)
` [PATCH 1/3] mpc85xx: i2c frequency
` [PATCH 2/3] Freescale I2C driver
` [PATCH 3/3] ppc: p2020rdb i2c support
(no subject)
2012-08-21 13:04 UTC (31+ messages)
` [PATCH 01/13] Makefile: add target to produce a SPL compatible uimage
` [PATCH 02/13] scripts: add tool to create image for SPI boot on AM35xx
` [PATCH 03/13] common: split out meminfo output and make it optional
` [PATCH 04/13] omap: add SPI as a boot mode for xload
` [PATCH 05/13] drivers/net/ksz8864rmn: add driver for Micrel KSZ8864RMN Ethernet Switch
` [PATCH 06/13] drivers/net: add driver for the EMAC device found in some TI SoCs
` [PATCH 07/13] omap3: allow enabling clocks for UART3, MMC1 and SPI
` [PATCH 08/13] drivers/spi: add driver for the Multichannel SPI controller found in TI SoCs
` [PATCH 09/13] m25p80: add JEDEC ID for Micron/Numonyx SPI NOR flash
` [PATCH 10/13] defaultenv: support NAND and NOR kernel partitions at the same time
` [PATCH 11/13] defaultenv: use /env/oftree if it exists
` [PATCH 12/13] defaultenv: support kernel and oftree on a filesystem
` [PATCH 13/13] omap3_clock: avoid initializing cores not present on TI AM35xx
[PATCH 1/1] arm: do not enable the previous bootz command
2012-08-20 12:09 UTC
tftp server
2012-08-18 19:12 UTC (3+ messages)
adding SPI port on i.MX27 board
2012-08-18 9:08 UTC (2+ messages)
[PATCH 1/1] spi: allow to dynamically allocate bus number
2012-08-18 9:05 UTC
[PATCH 0/4 v2] fs/mount: add autodetection support
2012-08-15 7:25 UTC (7+ messages)
` [PATCH 1/4] fs/mount: add autodetection type support
` [PATCH 2/4] filetype: add fat filesystem support
` [PATCH 3/4] fs/fat: add filetype
` [PATCH 4/4] command/mount: add autodetection support
[PATCH 0/7] smsc911x: runtime configuration improvement
2012-08-15 4:34 UTC (12+ messages)
` [PATCH 1/7] smc911x: move register define to smc911x.h
` [PATCH 2/7] smc911x: introduce read/write ops
` [PATCH 3/7] smc911x: add 16bit bus width support
` [PATCH 4/7] smc911x: add support to pass the shift via platform data
` [PATCH 5/7] smc911x: improve detection handle
` [PATCH 6/7] smc911x: update chip detection
` [PATCH 7/7] smm911x: check if the device is ready before using it
[for master PATCH 1/2] miidev: add phy_addr detection support
2012-08-15 4:32 UTC (4+ messages)
` [for master PATCH 2/2] calao: at91 qil/tny/usb auto detect the phy addr
vacation
2012-08-14 20:47 UTC
[PATCH 0/3 v2] omap: 4460 support
2012-08-14 20:03 UTC (5+ messages)
` [PATCH 1/3] Add support for OMAP4460 TPS62361
` [PATCH 2/3] OMAP4460: ram init changes
` [PATCH 3/3] OMAP4460: clock init
[PATCH 1/1] filetype: add command support
2012-08-13 21:53 UTC (2+ messages)
[PATCH v2] Add JTAG bitbang driver
2012-08-13 19:42 UTC (2+ messages)
[PATCH 0/3] omap: 4460 support
2012-08-13 19:08 UTC (5+ messages)
` [PATCH 1/3] Add support for OMAP4460 TPS62361
` [PATCH 3/3] OMAP4460: clock init
[PATCH 1/1] bootm: add global bootm.{image/initrd}.loadaddr support
2012-08-13 18:45 UTC (2+ messages)
[PATCH] OMAP4: use writel and readl
2012-08-13 18:42 UTC (3+ messages)
` [PATCH v2] "
[for master PATCH 0/4] Bootm uImage initrd fix
2012-08-13 18:38 UTC (6+ messages)
` [PATCH 1/4] arm/bootm: fix initrd_start init
` [PATCH 2/4] bootm: do not load the initrd in the common code
` [PATCH 3/4] uimage_sdram_flush: fix resource start
` [PATCH 4/4] uimage_laod: fix ramdisk support
[PATCH] ARM: enable MMU in pbl
2012-08-13 18:29 UTC (7+ messages)
` [PATCH 1/4] ARM __mmu_cache_*: Do not clobber registers
` [PATCH 2/4] ARM MMU: call __mmu_cache_* as regular C functions
` [PATCH 3/4] ARM pbl: enable MMU during decompression
` [PATCH 4/4] create a common ARM flush_icache function
[PATCH 0/4] fs/mount: add autodetection support
2012-08-13 10:56 UTC (11+ messages)
` [PATCH 1/4] fs/mount: add autodetection type support
` [PATCH 2/4] filetype: add fat filesystem support
` [PATCH 3/4] fs/fat: add filetype
` [PATCH 4/4] command/mount: add autodetection support
[PATCH 1/2] devices: fix missing converition to DEVICE_ID_DYNAMIC
2012-08-12 20:24 UTC (3+ messages)
` [PATCH 2/2] driver: set DEVICE_ID_DYNAMIC to -2 and DEVICE_ID_SINGLE to -1
[PATCH v2] pbl updates
2012-08-12 18:03 UTC (10+ messages)
` [PATCH 1/8] Makefile.lib: add disasm and ln commands
` [PATCH 2/8] Makefile: generate a barebox-flash-image link
` [PATCH 4/8] ARM s3c boards: Do not hardcode image sizes
` [PATCH 5/8] ARM boards: Make boards pbl safe
` [PATCH 6/8] ARM Makefile: Do not hardcode targets in MLO/netx/davinci/s5p
` [PATCH 7/8] ARM: fix netx/MLO/s5p image build for pbl
` [PATCH 8/8] ARM pbl: generate zbarebox.map in $(obj)
[PATCH] pbl updates
2012-08-12 13:24 UTC (19+ messages)
` [PATCH 1/9] ARM eukrea cpuimx25: Move flash_header to seperate file
` [PATCH 2/9] ARM s3c boards: Do not hardcode image sizes
` [PATCH 3/9] ARM boards: Make boards pbl safe
` [PATCH 4/9] ARM Makefile: Do not hardcode targets in MLO/netx/davinci/s5p
` [PATCH 5/9] ARM: fix netx/MLO/s5p image build for pbl
` [PATCH 6/9] ARM Makefile: generate a barebox-flash-image link
` [PATCH 7/9] ARM pbl: Fix zbarebox.S build
` [PATCH 8/9] ARM pbl: remove unnecessary FORCE
` [PATCH 9/9] ARM pbl: generate zbarebox.map in $(obj)
[PATCH 0/3] ppc: Freescale TSEC driver
2012-08-10 19:16 UTC (7+ messages)
` [PATCH V2 0/4] "
` [PATCH 1/4] ppc: GIANFAR base address definition
` [PATCH 2/4] net: GIANFAR driver
` [PATCH 3/4] fsl: Freescale TSEC specific initialization
` [PATCH 4/4] ppc: P2020RDB Ethernet configuration
[PATCH 1/2] at91: sam9260/sam9g20/sam9261/sam9g10/sam9263 add autodetect sdram size
2012-08-10 18:38 UTC (4+ messages)
` [PATCH 2/2] at91: Calao and Atmel reboard sam{9260/9g20/9261/9g10/9263}ek "
[PATCH] fix hush 'exit'
2012-08-10 10:58 UTC (3+ messages)
` [PATCH 1/2] hush: Make exit a shell builtin
` [PATCH 2/2] hush: catch errors from execute_binfmt
issue with imx35 external boot from Micron 4k flash
2012-08-10 9:18 UTC (2+ messages)
[PATCH] ARM/imx/pcm043: increase size of "self" partition
2012-08-10 9:07 UTC (3+ messages)
` [PATCH v2] "
[PATCH 1/3] mc13xxx: Added mc13xxx_revision() function
2012-08-10 8:44 UTC (6+ messages)
` [PATCH 2/3] mc13xxx: Hide private struct mc13xxx from other units
` [PATCH 3/3] mc13xxx: Fixed memory leak
Video issues with PCM043
2012-08-09 20:41 UTC
[PATCH] Add JTAG bitbang driver
2012-08-09 12:59 UTC (3+ messages)
[PATCH] ARM i.MX: Add support for i2c on imx6
2012-08-09 7:35 UTC (2+ messages)
[PATCH] commands: memset: fix help message
2012-08-09 6:44 UTC (2+ messages)
[PATCH 1/1] menu: add number key support
2012-08-09 6:40 UTC (2+ messages)
Reminder: Nataraj invites you to Twoo
2012-08-08 13:20 UTC
boot init code depending on i2c eeprom value
2012-08-07 13:54 UTC (4+ messages)
` Antwort: "
[PATCH 00/12 v4] Add Pre-Bootloader support
2012-08-06 7:23 UTC (14+ messages)
` [PATCH 01/12] Makefile.clean: include Makefiles again
` [PATCH 02/12] kbuild: add pre-bootloader (pbl) target
` [PATCH 03/12] Add pre-bootloader (pbl) image support
` [PATCH 04/12] pbl: discard unwind symbol if enable in barebox
` [PATCH 05/12] Add compressed image support
` [PATCH 06/12] decompressor: import malloc/free implementation for linux 3.4
` [PATCH 07/12] ARM: add early malloc support needed by the decompressor
` [PATCH 08/12] compressed image: add gzip support
` [PATCH 09/12] ARM pbl: Add .gitignore for generated files
` [PATCH 10/12] at91: add lowlevel init to the pbl
` [PATCH 11/12] kbuild: allow to have custom cppflags for pbl
` [PATCH 12/12] arm: always enable the garbage collector "
[PATCH 1/1] gadget: fix Kconfig: move config under if
2012-08-03 14:35 UTC (2+ messages)
[PATCH] Enable pull-up on Rx serial ports for the CALAO MB-QIL-A9260
2012-08-03 13:51 UTC (2+ messages)
[PATCH RFC] arm/imx: provide command to add ram device with autodetected size
2012-08-03 13:26 UTC (3+ messages)
` [PATCH v2] "
changing environment at build time
2012-08-03 13:22 UTC (4+ messages)
[PATCH 00/12 v3] Add Pre-Bootloader support
2012-08-03 7:06 UTC (5+ messages)
` [PATCH 01/12] kbuild: Init all relevant variables used in kbuild files so
` [PATCH 03/12] Add pre-bootloader (pbl) image support
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox