is there a standard for putting the name of a source file in the file?
2012-11-18 16:26 UTC (2+ messages)
ARM: pbl: short patches
2012-11-18 15:29 UTC (5+ messages)
` [PATCH 1/3] ARM: pbl: remove zbarebox.map during 'make clean'
` [PATCH 2/3] ARM: start-pbl.c: make errorfn() static
` [PATCH 3/3] ARM: start-pbl.c: unificate path to lib/decompress_*.c
[PATCH] arm lib: Remove redundant boot usage info from boot[uz].c
2012-11-18 13:39 UTC
[PATCH] mach-imx: Comment typo fix, "enviroment" -> "environment"
2012-11-18 13:30 UTC
[PATCH 0/7] phylib: fix + drivers
2012-11-18 12:49 UTC (8+ messages)
` [PATCH 1/7] driver: introduce device_probe to manully probe a device
` [PATCH 2/7] phylib: fix generic phy driver probe
` [PATCH 3/7] mdio_bus: fix match
` [PATCH 4/7] phylib: export phy_id via param
` [PATCH 5/7] phylib: introduction of forced 100Mbps
` [PATCH 6/7] phylib: add fixup support
` [PATCH 7/7] phylib: add micrel support
[RFC 0/3] MIPS: add pre-bootloader (pbl) image support
2012-11-17 12:10 UTC (4+ messages)
` [RFC 1/3] "
` [RFC 2/3] MIPS: boot: realize _start in C
` [RFC 3/3] MIPS: qemu-malta_defconfig: use pbl
[PATCH] MIPS: main_entry.c: fix typo
2012-11-17 9:23 UTC
[PATCH] bareboxenv.c: simple grammatical fix
2012-11-16 22:45 UTC
[PATCH] i.MX25 & 35 usb config bits : fix host power bit
2012-11-16 21:16 UTC
are there still issues with building sandbox on x86_64?
2012-11-16 20:27 UTC
[PATCH 1/1] led-gpio: add bicolor led support
2012-11-16 20:17 UTC
[PATCH 0/2] m25p80: re-import it againt mtd_add_host
2012-11-16 20:16 UTC (3+ messages)
after "git pull", building for beagle complains about missing "lzop"
2012-11-16 20:01 UTC (3+ messages)
[PATCH 0/7 v2] at91sam9 add watchdog support with keep alive
2012-11-16 17:55 UTC (8+ messages)
` [PATCH 1/7] watchdog: add keep alive support
` [PATCH 2/7] watchdog: add at91sam9 watchdog support
` [PATCH 3/7] at91sam9260/9g20: add wathdog support
` [PATCH 4/7] at91sam9261/9g10: "
` [PATCH 5/7] at91sam9263: "
` [PATCH 6/7] at91sam9g45: "
` [PATCH 7/7] at91sam9x5: "
[PATCH 1/1] at91sam9260ek: specify mach entry
2012-11-16 17:19 UTC (4+ messages)
` [PATCH 1/3] phylib: export phy_id via param
` [PATCH 2/3] phylib: introduction of forced 100Mbps
` [PATCH 3/3] macb/ether: split flags for drivers and phylib
[PATCH 0/7] at91sam9 add watchdog support with keep alive
2012-11-16 17:03 UTC (8+ messages)
` [PATCH 1/7] watchdog: add keep alive support
` [PATCH 2/7] watchdog: add at91sam9 watchdog support
` [PATCH 3/7] at91sam9260/9g20: add wathdog support
` [PATCH 4/7] at91sam9261/9g10: "
` [PATCH 5/7] at91sam9263: "
` [PATCH 6/7] at91sam9g45: "
` [PATCH 7/7] at91sam9x5: "
v2012.11.0 - The late one
2012-11-16 13:00 UTC
pedantry alert -- what is the proper spelling of "barebox"?
2012-11-16 11:33 UTC (3+ messages)
how easy to add extra config for NAND-less beagle?
2012-11-16 11:16 UTC (6+ messages)
common.h dependence leak
2012-11-16 7:01 UTC
[PATCH] replace barebox* in .gitignore with individual files
2012-11-15 17:28 UTC (2+ messages)
[PATCH 1/1] at91rm9200ek: add spi support
2012-11-15 16:21 UTC
[PATCH 1/1] phylib: split config start to connect
2012-11-15 14:11 UTC
[PATCH 1/1] mx53 loco: enable smsc phy driver
2012-11-15 14:11 UTC (4+ messages)
[PATCH 1/1] mci-core: fix debug Capacity cast
2012-11-15 13:41 UTC (2+ messages)
TX53: Not Bootable from next tree
2012-11-15 12:00 UTC (10+ messages)
` [TX53: boot fixes 0/2] Make TX53 bootable again
` [TX53: boot fixes 1/2] tx53: Fix unbootable TX53-8030
` [TX53: boot fixes 2/2] tx53: remove reset() when not doing lowlevel init
[PATCH 1/2] phy: add phy_drivers_register
2012-11-15 11:58 UTC (4+ messages)
` [PATCH 2/2] phy: add smsc phy driver support
` [PATCH 1/1 v2] "
[PATCH 1/1] mx53-loco: fix phy reset
2012-11-15 11:52 UTC (2+ messages)
[PATCH 1/1] mx53-loco: fix phy reset
2012-11-15 11:27 UTC (2+ messages)
[PATCH] imx53: implement imx53_add_kpp
2012-11-15 10:51 UTC
[PATCH 0/4 v3] at91sam9x5ek: add spi and mci support
2012-11-15 10:11 UTC (2+ messages)
[PATCH 0/2 v2] add bus device
2012-11-15 10:11 UTC (2+ messages)
[PATCH 1/1] phy: if the link partner just ack us wait the end of the autoneg
2012-11-15 9:29 UTC (4+ messages)
[PATCH 1/2] nios2: use barebox_add_memory_bank in generic.c
2012-11-15 7:47 UTC (3+ messages)
` [PATCH 2/2] nios2: update generic_defconfig
TX53-8030 Memory Speed
2012-11-15 7:46 UTC (2+ messages)
how to download a file to specified mem location using tftp
2012-11-15 7:41 UTC (6+ messages)
why eth0 not in /dev
2012-11-15 7:39 UTC (2+ messages)
[PATCH 1/1] phy: phy_update_status wait auto neg done when enabled
2012-11-14 17:24 UTC (5+ messages)
[PATCH] mci_spi: always compute command crc byte
2012-11-14 8:25 UTC (2+ messages)
[PATCH] ARM pbl: add generated file zbarebox.map to .gitignore
2012-11-14 8:23 UTC (2+ messages)
defaultenv-2: how to update a flash partition?
2012-11-14 8:10 UTC (4+ messages)
[PATCH 1/3] at91sam9: add detection of low power sdram
2012-11-13 21:13 UTC (3+ messages)
` [PATCH 2/3] usb-a9g20: add mmc spi support
` [PATCH 3/3] tny-a9g20: "
[PATCH 0/4] mci-spi fix
2012-11-13 20:07 UTC (5+ messages)
` [PATCH 1/4] mci_spi: always compute command crc byte
` [PATCH 2/4] mci-core: spi fix op cond support
` [PATCH 3/4] mci_spi: add sanity check
` [PATCH 4/4] mci_spi: add clock frequency change support
[PATCH 1/1] phylib: add fixup support
2012-11-13 18:00 UTC
[PATCH 0/8] atmtel: fix spi driver + rm9200
2012-11-13 14:45 UTC (11+ messages)
` [PATCH 1/8] atmel_spi: use device id as bus num
` [PATCH 2/8] atmel_spi: split transfert to atmel_spi_do_xfer
` [PATCH 3/8] atmel_spi: after setup the cs need to be disable
` [PATCH 4/8] atmel_spi: add sanity check in setup
` [PATCH 5/8] atmel_spi: fix cs support
` [PATCH 6/8] atmel_spi: drop setup during transfer
` [PATCH 7/8] atmel_spi: add cs change support
` [PATCH 8/8] at91rm9200: fix spi cs support
[PATCH] omap3_spi: fix bus numbers according to omap3_add_spi[1-4]
2012-11-12 8:38 UTC (2+ messages)
[PATCH v3 1/2] commands: change Y-Modem implementation
2012-11-12 8:36 UTC (4+ messages)
` [PATCH v3 2/2] commands: remove old "
[PATCH 1/1] at91sam9x5ek: add at24c512 support
2012-11-12 7:43 UTC (2+ messages)
[PATCH 1/1] eth: register device a pure device
2012-11-12 7:42 UTC (2+ messages)
[PATCH 0/3] i2c fix + prepare for at24 support
2012-11-12 7:40 UTC (2+ messages)
[PATCH 0/3] i2c: add at24 eeprom support
2012-11-12 7:38 UTC (5+ messages)
` [PATCH 1/3] import log2 support from linux
` [PATCH 2/3] add roundup and rounddown support
` [PATCH 3/3] eeprom: add at24 support
[PATCH 1/1] at91rm9200ek: enable dt support
2012-11-12 7:33 UTC (2+ messages)
[PATCH 0/2 v4] add spi command
2012-11-12 7:32 UTC (4+ messages)
` [PATCH 1/2] spi: introduce spi_get_master
` [PATCH 2/2] introduce spi command
[PATCH] net smc911x: add support for external PHY
2012-11-12 7:30 UTC (2+ messages)
[PATCH] mdiobus: unbreak phy_device_connect(): honor masked out PHYs
2012-11-12 7:28 UTC (2+ messages)
[PATCH] make new y-modem (PATCH v2) work on big-endian CPU
2012-11-08 19:59 UTC (5+ messages)
[PATCH 0/2] Y-Modem implementation change
2012-11-07 8:22 UTC (12+ messages)
` [PATCH v2 1/2] commands: change Y-Modem implementation
` [PATCH v2 2/2] commands: remove old "
[PATCH] mdiobus: unbreak phy_device_connect() "scan all PHY addresses" feature
2012-11-07 8:05 UTC (2+ messages)
USB On PCM043?
2012-11-06 19:48 UTC (9+ messages)
` [RFC][PATCH] pcm043: usb support --not working--
TX53: Not Bootable from next tree
2012-11-05 13:27 UTC (3+ messages)
[PATCH 0/2 v3] add spi command
2012-11-05 9:36 UTC (3+ messages)
` [PATCH 1/2] spi: introduce spi_get_master
` [PATCH 2/2] introduce spi command
Ramfs and NULL pointer
2012-11-05 8:23 UTC (4+ messages)
[PATCH 1/1] atmel_spi: fix multiple instance support
2012-11-04 18:42 UTC
[PATCH 0/2 v2] add spi command
2012-11-04 8:59 UTC (3+ messages)
` [PATCH 1/2] spi: introduce spi_get_master
` [PATCH 2/2] introduce spi command
[PATCH 0/2] add spi command
2012-11-03 21:39 UTC (4+ messages)
` [PATCH 1/2] spi: introduce spi_get_master
` [PATCH 2/2] introduce spi command
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox