[PATCH 01/13] ARM: clep7212: Migrate to config-board
2013-03-11 16:22 UTC (19+ messages)
` [PATCH 02/13] ARM: clps711x: Fix setup bus wait state scaling factor for 13Mhz mode
` [PATCH 03/13] ARM: clps711x: Replace numeric PLL option with boolean for raise CPU frequency
` [PATCH 04/13] ARM: clps711x: Add clocksource driver
` Re[2]: "
` [PATCH 05/13] ARM: clps711x: Using COMMON_CLK
` Re[2]: "
` [PATCH 06/13] Add Generic GPIO driver
` [PATCH 07/13] ARM: clps711x: Add "
` [PATCH 08/13] Add helpers to define resources
` [PATCH 09/13] ARM: clps711x: Migrate to using DEFINE_RES_MEM macro
` [PATCH 10/13] ARM: clps711x: Limit chipselect setup up to CS5
` [PATCH 11/13] Add system controller register driver (SYSCON)
` [PATCH 12/13] ARM: clps711x: Export system-wide registers through SYSCON driver
` [PATCH 13/13] serial: clps711x: Migrate to using "
[PATCH 1/2] Makefile: Create empty <config.h> if this header file is not needed by board
2013-03-11 16:10 UTC (2+ messages)
` [PATCH 2/2] Remove unused config.h
[RFC] Makefile: Create empty <config.h> if this header file is not needed by board
2013-03-11 16:10 UTC (6+ messages)
` Re[2]: "
New dt-only arm/mach
2013-03-11 11:04 UTC (5+ messages)
` Re[2]: "
[PATCH 0/9] ARM: add support for Zynq
2013-03-11 10:06 UTC (14+ messages)
` [PATCH 1/9] serial: Add driver for Cadence UART
` [PATCH 2/9] ARM: Zynq: Add new architecture zynq
` [PATCH 3/9] ARM: zynq: add zynq fsbl checksum script
` [PATCH 4/9] ARM: zynq: Add support for the Avnet Zedboard
` [PATCH 5/9] ARM: zynq: add clk support for zynq7000
` [PATCH 6/9] ARM: zynq: clk: replace define with header
` [PATCH 7/9] ARM: zynq: clk: add pll type
` [PATCH 8/9] ARM: zynq: clk: convert to platform driver
` [PATCH 9/9] ARM: zynq: remove clocksource
[PATCH] image and bss size decrease
2013-03-11 9:08 UTC (14+ messages)
` [PATCH 01/10] mips: initialize malloc pool before start_barebox()
` [PATCH 02/10] nios: "
` [PATCH 03/10] openrisc: "
` [PATCH 04/10] blackfin: "
` [PATCH 05/10] x86: "
` [PATCH 06/10] bus: Make struct device a pointer
` [PATCH 07/10] command: remove list_head from struct command
` [PATCH 08/10] command: remove statically initialized aliases
` [PATCH 09/10] fs: allocate FILE table dynamically
` [PATCH 10/10] gpio: allocate gpio_desc "
[PATCH 0/9] Add support for booting ArchosG9 from sd-card
2013-03-11 8:50 UTC (20+ messages)
` [PATCH 1/9] defaultenv-2: don't load nonexistent file
` [PATCH 2/9] omap4_romusb: rename omap4_usbboot_pdata to omap4_usbboot_data
` [PATCH 3/9] omap_uart: rename OMAP3EVM_UARTx to OMAP_UARTx
` [PATCH 4/9] omap_uart: add low level port serial initialization
` [PATCH 5/9] panda: remove unused configuration items
` [PATCH 6/9] omap4_romusb: allow adding usb-serial when not booting from usb
` [PATCH 7/9] menu: avoid errors when building submenus
` [PATCH 8/9] archos: add atag appender for all features
` [PATCH 9/9] archosg9: enable booting from sd-card
[PATCH v2] DMO Realq7 support
2013-03-11 8:23 UTC (5+ messages)
` [PATCH 1/4] net: phy: micrel: Update id table from kernel
` [PATCH 2/4] ARM i.MX6: Add mmdc calibration support
` [PATCH 3/4] Add DMO RealQ7 board support
` [PATCH 4/4] Add DMO RealQ7 defconfig
[PATCH] net: fec: Use standard phy type defines
2013-03-11 7:53 UTC (7+ messages)
` [PATCH 1/2] net: fec: drop sevenwire support
` [PATCH 2/2] net: fec: use standard phy type defines
Question about OMAP4 boot priorities
2013-03-11 0:43 UTC
[PATCH 0/4] ArchosG9: add keyboard input and new reset menu entries
2013-03-10 23:36 UTC (5+ messages)
` [PATCH 1/4] gpio_keys: detect keys pressed before booting
` [PATCH 2/4] twl6030: add power button as an input key
` [PATCH 3/4] OMAP4: add command to select next boot device priority
` [PATCH 4/4] ArchosG9: add keyboard input and new reset menu entries
[PATCH] usb: chipidea-imx: Fix usb initialization
2013-03-10 23:17 UTC (2+ messages)
[PATCH] misc cleanups
2013-03-10 10:19 UTC (5+ messages)
` [PATCH 1/4] include asm/sections.h instead of asm-generic/sections.h
` [PATCH 2/4] MMC i.MX: remove unnecessary mach include
` [PATCH 3/4] ARM i.MX: Add double include protection for generic.h
` [PATCH 4/4] ARM: Add missing barebox_arm_boarddata function
[PATCH 0/7] Rework current Tegra support
2013-03-10 9:53 UTC (16+ messages)
` [PATCH v2 0/5] "
` [PATCH v2 1/5] tegra: pull in iomap.h from the Linux kernel
` [PATCH v2 2/5] tegra: switch to ARMv7 cpu type
` [PATCH v2 3/5] tegra: add driver for the clock and reset module
` [PATCH v2 4/5] tegra: add proper timer driver
` [PATCH v2 5/5] tegra: add power management controller driver
[PATCH v2 1/6] Extend device_platform_driver macro
2013-03-10 6:41 UTC (6+ messages)
` [PATCH v2 2/6] Add more drivers to using device_platform_driver()
` [PATCH v2 3/6] Introduce console_platform_driver() macro and use it for serial drivers
` [PATCH v2 4/6] SPI: Rename spi_register_driver() for using with register_driver_macro()
` [PATCH v2 5/6] I2C: Rename i2c_register_driver() "
` [PATCH v2 6/6] Introduce device_spi_driver() macro and use it for SPI drivers
[PATCH] Extend device_platform_driver macro
2013-03-09 21:10 UTC (6+ messages)
` Re[2]: "
[PATCH] Add DataModul Realq7 board support
2013-03-09 19:03 UTC (14+ messages)
` [PATCH 1/3] ARM i.MX6: Add mmdc calibration support
` [PATCH 2/3] Add DMO RealQ7 board support
` [PATCH 3/3] Add DMO RealQ7 defconfig
[PATCH] Make: update setlocalversion from the kernel
2013-03-09 11:12 UTC
[PATCH 00/11 v6] introduction of dmesg support
2013-03-09 10:25 UTC (17+ messages)
` [PATCH 01/11] kfifo: introduce kfifo_dump_str to dump the fifo
` [PATCH 02/11] console: switch to kfifo_dump_str
` [PATCH 03/11] intoduce dmesg to print the barebox printk to dmesg ring buffer
` [PATCH 04/11] startup: switch to pr_xxx
` [PATCH 05/11] at91: clock switch to pr_info
` [PATCH 06/11] meminfo: switch to pr_xxx
` [PATCH 07/11] net/console: "
` [PATCH 08/11] startup: "
` [PATCH 09/11] barebox_banner: switch to pr_info
` [PATCH 10/11] net/phy: convert "
` [PATCH 11/11] ext4: switch debug and printf to dev_xxx
[PATCH 0/5] Zynq support for barebox
2013-03-08 19:31 UTC (11+ messages)
Status Tegra 2/3 Support
2013-03-08 14:44 UTC (2+ messages)
[PATCH 2/2] ARM: OMAP: beagle: Add missing MMC iomux setup
2013-03-08 13:00 UTC (8+ messages)
` [PATCH 1/1] beagle: add missing mmc twl and control init
[PATCH] ata/ahci work
2013-03-08 10:35 UTC (6+ messages)
` [PATCH 1/5] ata: ahci: fix wrong link check
` [PATCH 2/5] ata: add ata logical device to defer probe
` [PATCH 3/5] ata: Add init callback to ata_port_operations
` [PATCH 4/5] ata: ahci: implement init callback
` [PATCH 5/5] ata: ahci: refactor init functions
[PATCH] usb: ehci: initialize ehci_data
2013-03-08 7:24 UTC (3+ messages)
[PATCH 0/9 v5] introduction of dmesg support
2013-03-07 21:25 UTC
[PATCHv2 0/2] cfa10036: Retrieve RAM size at runtime
2013-03-07 14:26 UTC (6+ messages)
` [PATCH 1/2] memsize: Make get_ram_size RAM proof
v2013.02.0 phyCORE-OMAP4 MLO to big
2013-03-07 11:19 UTC (5+ messages)
` Antwort: "
[RFC PATCH 00/20] introduce application support
2013-03-07 9:17 UTC (10+ messages)
` [PATCH 01/20] Makefile: x_flags prepare for apps support
` [PATCH 02/20] tlsf_malloc: drop duplicate include
` [PATCH 06/20] app: add some utils
[PATCH 0/9 v4] introduction of dmesg support
2013-03-07 7:30 UTC (4+ messages)
` [PATCH 1/9] kfifo: introduce kfifo_dump_str to dump the fifo
` [PATCH 3/9] intoduce dmesg to print the barebox printk to dmesg ring buffer
[PATCH] fix another brown paper bag bug introduced with compile time loglevel
2013-03-07 7:21 UTC
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox