[PATCH 1/2] add driver for Tegra124 memory controller
2017-03-20 7:41 UTC (3+ messages)
` [PATCH 2/2] ARM: tegra: enable Tegra124 memory controller driver in defconfig
[PATCH] ata: ide-sff: add LBA48 support
2017-03-20 7:41 UTC
[PATCH] ARM: i.MX WaRP7: Add defaultenv and boot pre-installed kernel
2017-03-20 7:39 UTC (2+ messages)
[PATCH] ARM: dts: i.MX7 WaRP7: remove wdog1 pinctrl workaround
2017-03-20 7:33 UTC (2+ messages)
[PATCH] ARM: i.MX7: Kconfig: ARCH_IMX7 selects PINCTRL_IMX_IOMUX_V3
2017-03-20 7:30 UTC (2+ messages)
[PATCH 1/3] ARM: tegra: jetson-tk1: adapt internal DT paths to changed upstream DT
2017-03-20 7:30 UTC (4+ messages)
` [PATCH 2/3] ARM: tegra124: use old XUSB binding
` [PATCH 3/3] ARM: tegra: jetson-tk1: use phandle for stdout path
[PATCH] ARM: mvebu: remove obsolete select
2017-03-20 7:03 UTC (2+ messages)
Barebox State Framework
2017-03-20 7:01 UTC (4+ messages)
[PATCH 0/3] fix "no previous prototype" warnings
2017-03-20 6:59 UTC (4+ messages)
` [PATCH 1/3] gui: bmp.c: fix "no previous prototype" warning
` [PATCH 2/3] clk: clk-gate-shared: "
` [PATCH 3/3] gui: image_renderer: fix "no previous prototype for 'image_renderer_unregister'" warning
[PATCH v2 00/11] AT91, at91sam9x5ek updates (part II/III)
2017-03-20 3:21 UTC (14+ messages)
` [PATCH v2 01/11] clocksource: at91: Add DT compatibility table
` [PATCH v2 02/11] serial: atmel: "
` [PATCH v2 03/11] clk: at91: Port at91 DT clock code
` [PATCH v2 04/11] mci: Allow parsing for explicit DT node
` [PATCH v2 05/11] mci: atmel_mci: Add DT support
` [PATCH v2 06/11] spi: atmel_spi: "
` [PATCH v2 07/11] w1-gpio: "
` [PATCH v2 08/11] usb: ohci-at91: "
` [PATCH v2 09/11] usb/host: Allow USB_OHCI_AT91 even if USB_OHCI is disabled
` [PATCH v2 10/11] usb: echi-atmel: Add DT support
` [PATCH v2 11/11] net: macb: "
[PATCH] fixup! clk: at91: Port at91 DT clock code
2017-03-20 3:08 UTC
[PATCH v3 0/4] upstream hwrng framework
2017-03-17 15:46 UTC (5+ messages)
` [PATCH v3 1/4] drivers: add simple hw_random implementation
` [PATCH v3 2/4] lib: random: get_random_bytes from HWRNG if present
` [PATCH v3 3/4] caamrng: port to hwrng framework
` [PATCH v3 4/4] fs: add random device
[PATCH v2 0/3] upstream hwrng framework
2017-03-17 14:30 UTC (6+ messages)
` [PATCH v2 1/3] drivers: add simple hw_random implementation
` [PATCH v2 2/3] lib: random: get_random_bytes from HWRNG if present
` [PATCH v2 3/3] caamrng: port to hwrng framework
[PATCH 00/11] AT91, at91sam9x5ek updates (part II/III)
2017-03-15 21:03 UTC (15+ messages)
` [PATCH 01/11] clocksource: at91: Add DT compatibility table
` [PATCH 02/11] serial: atmel: "
` [PATCH 03/11] clk: at91: Port at91 DT clock code
` [PATCH 04/11] mci: Allow parsing for explicit DT node
` [PATCH 05/11] mci: atmel_mci: Add DT support
` [PATCH 06/11] spi: atmel_spi: "
` [PATCH 07/11] w1-gpio: "
` [PATCH 08/11] usb: ohci-at91: "
` [PATCH 09/11] usb/host: Allow USB_OHCI_AT91 even if USB_OHCI is disabled
` [PATCH 10/11] usb: echi-atmel: Add DT support
` [PATCH 11/11] net: macb: "
[PATCH v2] clk: No-op CLK_OF_DECLARE if not enabled
2017-03-15 8:07 UTC (2+ messages)
[PATCH] ARM: zynq7000: make PS_CLK Kconfigurable
2017-03-15 8:05 UTC (2+ messages)
[PATCH] efi: clocksoure: make sure the meassured frequency is valid
2017-03-15 7:27 UTC (2+ messages)
[PATCH] ARM: i.MX: GuF Santaro: Detect and enable touch controller
2017-03-14 14:14 UTC
[PATCH 0/5] EFI Secure boot support
2017-03-14 9:48 UTC (19+ messages)
` [PATCH 1/5] efi: add more security related guid for the efivars
` [PATCH 2/5] efi: fix lds for secure boot support
` [PATCH 3/5] efi: fix secure and setup mode report
` [PATCH 4/5] boot: if we are in secure boot mode
` [PATCH 5/5] efi: enable sercure boot support
[PATCH v1 1/3] drivers: add simple hw_random implementation
2017-03-14 7:55 UTC (4+ messages)
` [PATCH v1 2/3] hw_random: add driver for Freescale RNGC
` [PATCH v1 3/3] lib: random: get_random_bytes from HWRNG if present
[PATCH v1 0/2] upstream nvmem patches
2017-03-14 7:36 UTC (4+ messages)
` [PATCH v1 1/2] drivers: add nvmem framework from kernel
` [PATCH v1 2/2] nvmem: add simple nvstore driver
[PATCH] net/phy: marvell: import support for 88E1111 from the Linux
2017-03-14 7:19 UTC (5+ messages)
[PATCH] arm: baltos: enable mPCIe slot and configure external GPIO controller
2017-03-14 7:18 UTC (2+ messages)
[PATCH v2] poweroff: Allow to register poweroff handlers
2017-03-14 7:17 UTC (2+ messages)
[PATCH 0/8] add generic EFI timer
2017-03-14 7:16 UTC (8+ messages)
` [PATCH 1/8] efi: add prototype and definition for creating and closing event
` [PATCH 7/8] efi: clocksoure: use event for timer
` [PATCH] fixup! efi: clocksoure: add EFI event timer
[PATCH 1/2] efi: load the protocol expected by the driver
2017-03-14 7:13 UTC (3+ messages)
` [PATCH 2/2] efi: only iterate over handles that provide the device path protocol
[PATCH v3 0/4] upstream led blinking rework
2017-03-14 7:11 UTC (6+ messages)
` [PATCH v3 1/4] led: add blinking/flashing and led_blink_pattern interface
` [PATCH v3 2/4] led: Add blink/flash to led command
` [PATCH v3 3/4] led: trigger: Use led triggers
` [PATCH v3 4/4] led-trigger: Allow multiple led triggers of the same type
[PATCH 1/2] mtd: create bitflips in the correct page
2017-03-14 7:10 UTC (2+ messages)
` [PATCH 2/2] mtd: when creating bitflips the offset has to be page aligned
[PATCH 0/12] EFI: drop arch efi
2017-03-13 10:48 UTC (5+ messages)
[PATCH v1] poweroff: Allow to register poweroff handlers
2017-03-13 10:46 UTC (2+ messages)
[PATCH 0/2] efivarfs: rework the filesystem to make it human readable
2017-03-13 10:19 UTC (5+ messages)
[PATCH v1 0/4] upstream led blinking rework
2017-03-13 8:36 UTC (12+ messages)
` [PATCH v1 1/4] led: Allow blinking/flashing on led level
` [PATCH v1 2/4] led: Add blink/flash to led command
` [PATCH v1 3/4] led: trigger: Use led triggers
` [PATCH v1 4/4] led-trigger: rework
` [PATCH v2 0/4] upstream led blinking rework
` [PATCH v2 1/4] led: add blinking/flashing and led_blink_pattern interface
` [PATCH v2 2/4] led: Add blink/flash to led command
` [PATCH v2 3/4] led: trigger: Use led triggers
` [PATCH v2 4/4] led-trigger: rework
[PATCH] arm: baltos: define baltos_sram_init() return type as void
2017-03-13 8:13 UTC (2+ messages)
[PATCH 1/3] console_countdown: width to of countdown to 4 digits
2017-03-13 8:07 UTC (15+ messages)
` [PATCH 2/3] console_countdown: add possibility to abort countdown by external commands
` [PATCH 3/3] fastboot: abort autoboot timeout when fastboot gadget is activated
` [PATCH v2 1/3] console_countdown: width to of countdown to 4 digits
` [PATCH v2 2/3] console_countdown: add possibility to abort countdown by external commands
` [PATCH v3 0/3] upstream console_countdown related work
` [PATCH v3 1/3] console_countdown: width to of countdown to 4 digits
` [PATCH v3 2/3] console_countdown: add possibility to abort countdown by external commands
` [PATCH v3 3/3] fastboot: abort autoboot timeout when fastboot gadget is activated
` [PATCH v2 "
[PATCH] fixup! clk: No-op CLK_OF_DECLARE if not enabled
2017-03-13 7:21 UTC (3+ messages)
[PATCH 1/1] fix: console: expose consoles in devfs
2017-03-13 7:19 UTC (2+ messages)
[PATCH 2/2] efi: add serial driver support
2017-03-12 12:07 UTC (4+ messages)
` [PATCH 2/2 v2] "
[PATCH 1/4] led: Allow blinking/flashing on led level
2017-03-11 14:04 UTC (5+ messages)
` [PATCH 2/4] led: Add blink/flash to led command
` [PATCH 3/4] led: trigger: Use led triggers
` [PATCH 4/4] led-trigger: rework
[PATCH 1/3] import linux __iowrite32/64_copy support
2017-03-10 14:30 UTC (6+ messages)
` [PATCH 2/3] x86: add __raw_read{b,w,l,q} and __raw_write{b,w,l,q}
` [PATCH 3/3] fbcon: use __iowrite{32/64} to speedup the framebuffer console scrolling
e1000 driver hangs during probe
2017-03-10 13:09 UTC (6+ messages)
[PATCH 1/2] parameter: fix read only int support
2017-03-10 9:37 UTC (5+ messages)
` [PATCH 2/2] video: some framebuffer such as efi does support enable/disable
[PATCH 1/2] bbu: Search for cdev names aswell
2017-03-10 9:17 UTC (5+ messages)
` [PATCH 2/2] usb: fastboot: umount device before writing to it
v2017.03.0
2017-03-10 8:09 UTC
[PATCH] video: call fb_[en|dis]able instead of fops directly
2017-03-10 7:08 UTC
[PATCH 00/20] AT91, at91sam9x5ek updates (part I/III)
2017-03-09 10:54 UTC (3+ messages)
` [PATCH 08/20] clk: No-op CLK_OF_DECLARE if not enabled
[PATCH 0/2] add support of efi Serial IO and Graphics Output Protocol
2017-03-09 8:49 UTC (4+ messages)
` [PATCH 1/2] video: add EFI Graphics Output Protocol support
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox