[PATCH] pinctrl-single: Handle "pinctrl-single, function-mask" dt property
2020-01-20 8:33 UTC (2+ messages)
[PATCH 1/4] optee: move optee_verify_header() to common
2020-01-20 8:21 UTC (5+ messages)
` [PATCH 2/4] ARM: add optee early loading function
` [PATCH 3/4] ARM: mach-imx: OPTEE PBL configures PL210
` [PATCH 4/4] user: add documentation for OP-TEE loading
[PATCH] pinctrl: imx-v3: Support for imx6ull-iomuxc-snvs
2020-01-20 8:05 UTC (2+ messages)
[PATCH] nvmem: ocotp: Support for i.MX6ULL/ULZ
2020-01-20 8:04 UTC (2+ messages)
[PATCH] net: designware: eqos: don't funnel all MDIO writes to register 0
2020-01-20 7:53 UTC (2+ messages)
[PATCH] lds: Fix alignment of initcall table
2020-01-17 11:12 UTC (3+ messages)
Cannot get 'wd' to appear
2020-01-17 10:58 UTC (3+ messages)
[PATCH 00/10] Add Raspberry Pi USB support
2020-01-16 17:25 UTC (23+ messages)
` [PATCH 01/10] usb: Make timeout unit clear
` [PATCH 02/10] of: Add of_bus_n_xxx_cells()
` [PATCH 03/10] device: Introduce dma_offset
` [PATCH 04/10] of: Read dma_offset from device tree
` [PATCH 05/10] usb: Add usbroothubdes.h
` [PATCH 06/10] regulator: add function to get regulator by its name
` [PATCH 07/10] rpi: Enable USB Power domain during startup
` [PATCH 08/10] usb: Forward error code from usb_set_configuration
` [PATCH 09/10] usb: Add dwc2 host driver
` [RFC PATCH 0/7] usb: "
` [RFC PATCH 1/7] usb: dwc2: Add host controller driver
` [RFC PATCH 2/7] usb: dwc2: host: Handle dma mapping errors
` [RFC PATCH 3/7] usb: dwc2: Dynamic fifo size support from Linux
` [RFC PATCH 4/7] usb: dwc2: Rework roothub interface
` [RFC PATCH 5/7] HACK: usb: dwc2: Fix toggle reset
` [RFC PATCH 6/7] usb: dwc2: Rewrite dwc2_hc_init
` [RFC PATCH 7/7] usb: dwc2: Read dr_mode from device tree
` [PATCH 10/10] ARM: rpi_defconfig: Enable networking support
[yocto] #yocto bootchooser: Cannot get state 'state'
2020-01-16 15:13 UTC (9+ messages)
[PATCH] Revert "clocksource: ARMv8 timer can only be built on ARMv8"
2020-01-16 14:40 UTC (3+ messages)
[PATCH 0/5] Add support for Kalray k1c core
2020-01-16 13:34 UTC (20+ messages)
` [PATCH 1/5] k1c: Initial Kalray Coolidge (k1c) architecture support
` [PATCH 2/5] k1c: Add processor definitions
` [PATCH 3/5] k1c: Add support for device tree
` [PATCH 4/5] clocksource: k1c: Add k1c clocksource support
` [PATCH 5/5] watchdog: k1c: Add k1c watchdog support
[PATCH] fs: jffs2: add initial support for reading jffs2
2020-01-16 11:21 UTC
[PATCH] MIPS: actually use CONFIG_MIPS_RELOCATION_TABLE_SIZE
2020-01-16 8:35 UTC (2+ messages)
[PATCH] imx25: drop global over-current setting for USB
2020-01-16 8:30 UTC (2+ messages)
[PATCH] ARM: qemu-virt64: convert to assembly entry
2020-01-16 8:28 UTC (2+ messages)
qemu arm vexpress / virt32 support
2020-01-14 22:15 UTC (3+ messages)
[RFC 0/5] WIP: MIPS: implement dma mapping functions
2020-01-14 21:03 UTC (12+ messages)
` [RFC 1/5] WIP: MIPS: configure ebase according CONFIG_MMU
` [RFC 2/5] WIP: MIPS: implement dma mapping functions
` [RFC 3/5] net: e1000: make it work on MIPS
` [RFC 4/5] net: rtl8169: make it work on big-endian system
` [RFC 5/5] MIPS: qemu-malta_defconfig: enable e1000 network driver
qemu arm virt64 hangs
2020-01-14 20:22 UTC (2+ messages)
barebox-2020.01.0
2020-01-14 14:08 UTC
[PATCH] MIPS: dts: rename tplink-mr3020.dts -> ar9331_tl_mr3020.dts
2020-01-14 12:41 UTC (2+ messages)
[PATCH] usb: ehci: Do not use memset on dma coherent memory
2020-01-14 11:56 UTC
[PATCH 1/3] serial: cadence: move register definitions into header file
2020-01-14 11:07 UTC (4+ messages)
` [PATCH 2/3] serial: cadence: add lowlevel init and putc functions
` [PATCH 3/3] ARM: zynq: zedboard: add PBL console support
[PATCH] ARM: zynq: zed: partially revert zynq_cpu_lowlevel_init() chnages
2020-01-14 11:07 UTC (2+ messages)
[PATCH 1/2] PCI: layerscape: rename variable
2020-01-14 8:50 UTC (2+ messages)
` [PATCH 2/2] PCI: layerscape: Fixup iommu-map properties
barebox for iMX8MMini crashes while usb_rescan for USB type A
2020-01-13 11:04 UTC (2+ messages)
[PATCH 0/5] ARM: Layerscape: Add Fixups for Linux IOMMU support
2020-01-10 11:54 UTC (6+ messages)
` [PATCH 1/5] ARM: Layerscape: replace overcomplicated macros
` [PATCH 2/5] include/soc/fsl: remove unused function prototypes
` [PATCH 3/5] include/soc/fsl: Make struct ccsr_qman v3 specific
` [PATCH 4/5] net: fsl-fman: Do not put hardware in reset before Linux start
` [PATCH 5/5] ARM: Layerscape: setup icids for the IOMMU
[PATCH] images: gitignore more files
2020-01-10 11:42 UTC
[PATCH] include/linux/amba/bus.h: drop unused declarations
2020-01-08 11:42 UTC (2+ messages)
[PATCH 1/3] esdhc-pbl: allow to skip starting i.MX8 image
2020-01-08 11:41 UTC (4+ messages)
` [PATCH 2/3] ARM: nxp-imx8mq-evk: fix second stage booting
` [PATCH 3/3] esdhc-pbl: remove now unused imx8_esdhc_load_piggy
[PATCH v3] habv4: imx change signing area from full to the executed image
2020-01-08 11:26 UTC (2+ messages)
[PATCH 1/2] ARM: zynq: add Zynq specific lowlevel CPU init function
2020-01-08 11:25 UTC (3+ messages)
` [PATCH 2/2] ARM: zynq: zed: use zynq_cpu_lowlevel_init()
[RFC PATCH 0/5] fs: fat: extend for in-PBL support
2020-01-08 11:23 UTC (8+ messages)
` [RFC PATCH 1/5] pbl: add block I/O API
` [RFC PATCH 2/5] fs: fat: extend for in-PBL support
` [RFC PATCH 3/5] mci: add first-stage at91-sdhci driver
` [RFC PATCH 4/5] ARM: at91: add helpers for MCI barebox chain-loading
` [RFC PATCH 5/5] [WIP] ARM: at91: sama5d27-som1: add first stage entry point
Watchdog Timer with x86 processor
2020-01-07 15:38 UTC (5+ messages)
[PATCH 1/4] ARM: bcm2835 mbox: Remove response valid check
2020-01-07 10:19 UTC (4+ messages)
` [PATCH 2/4] gpio: Add raspberrypi exp gpio driver
` [PATCH 3/4] ARM: bcm2835 mbox: use pr_* to print messages
` [PATCH 4/4] ARM: rpi_defconfig: Enable raspberry GPIO exp driver
Why the internal kernel header?
2020-01-07 10:02 UTC (2+ messages)
[PATCH v2] habv4: imx change signing area from full to the executed image
2020-01-06 14:42 UTC (5+ messages)
[PATCH] ARM: nitrogen6: add lowlevel UART initialization
2020-01-06 10:09 UTC (4+ messages)
[PATCH] MIPS: loongson: rename CPU_LOONGSON1 to CPU_GS232
2020-01-06 9:42 UTC (2+ messages)
[PATCH] lds: align RO_DATA_SECTION members
2019-12-26 9:11 UTC (2+ messages)
selected processor does not support `rev r7,r7'
2019-12-25 8:32 UTC (8+ messages)
` STM32MP1 SoC support in latest Barebox
[PATCH 0/3] ARM64 early cache fixes
2019-12-20 16:14 UTC (8+ messages)
` [PATCH 1/3] ARM64: entry: save/restore potentially clobbered registers
` [PATCH 2/3] ARM: cache_64: invalidate dcache in arm_early_mmu_cache_invalidate
` [PATCH 3/3] ARM: cache_64: invalidate icache in arm_early_mmu_cache_flush
[PATCH] fixup! ARM: zii-imx8mq-dev: add DT fixups
2019-12-20 15:17 UTC (2+ messages)
[PATCH 1/4] ARM: nxp-imx8mq-evk: switch to SPDX license header
2019-12-20 15:15 UTC (5+ messages)
` [PATCH 2/4] ARM: nxp-imx8mq-evk: switch the PBL memcpy parameters to common variables
` [PATCH 3/4] ARM: nxp-imx8mq-evk: clean up nxp_imx8mq_evk_start
` [PATCH 4/4] ARM: nxp-imx8mq-evk: fix bootflow comment
[PATCH v2] lds: align RO_DATA_SECTION members
2019-12-20 15:12 UTC (2+ messages)
[PATCH 1/4] clk: zynq: add QSPI reference clock
2019-12-20 15:11 UTC (5+ messages)
` [PATCH 2/4] spi: add Zynq QSPI controller driver
` [PATCH 3/4] ARM: zynq: add QSPI DT node
` [PATCH 4/4] ARM: zynq: zed: add QSPI flash support
[PATCH] ARM: aarch64: Add support for passing initrd to Linux
2019-12-20 15:08 UTC (2+ messages)
[PATCH] ARM: i.MX: Fix PBL size test
2019-12-20 14:43 UTC
[PATCH] driver: add function to look up device by DT node
2019-12-19 10:55 UTC (3+ messages)
USB type-A in imx8mm
2019-12-19 7:20 UTC
[PATCH] ARM: rpi: Do not warn when firmware doesn't pass a dtb
2019-12-19 4:48 UTC
[PATCH 1/3] ARM: zii-imx8mq-dev: make eMMC update target the default
2019-12-18 15:13 UTC (8+ messages)
` [PATCH 2/3] ARM: zii-imx8mq-dev: add DT fixups
[PATCH] ARM: rdu1: add default environment
2019-12-18 7:32 UTC (2+ messages)
[PATCH 1/3] RDU2: add support to boot from SD card autonomosly
2019-12-18 7:31 UTC (2+ messages)
[PATCH] ARM: rdu-common: restart machine after fixing i210 device ID
2019-12-18 7:30 UTC (2+ messages)
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox