* v2021.08.0
@ 2021-08-23 14:27 Sascha Hauer
0 siblings, 0 replies; only message in thread
From: Sascha Hauer @ 2021-08-23 14:27 UTC (permalink / raw)
To: Barebox List
Hi All,
I am happy to announce barebox-2021.08.0.
There are some interesting changes this time. Finally deep probe support
has landed. Deep probe is a new way of handling dependencies between
devices. With device tree support dependencies are now very well
expressed in the device tree, so this information is used to probe a
device another device depends on just when it's needed. This makes
-EPROBE_DEFER unnecessary, which was (and still is) present in barebox,
but never worked very well. Deep probe is enabled per board, so you are
encouraged to enable it for your favourite board and see if it still
works.
Other than that the Rockchip rk3568 support is now pretty much
completed. Board support for the rk3568-EVB is added, so it's ready to
be used.
For a full list of changes see below.
Have Fun!
Sascha
----------------------------------------------------------------
Ahmad Fatoum (73):
nvmem: bsec: remove unused, left-over, struct member
nvmem: treat devices without nvmem_bus::write as read only
nvmem: add support for new read-only memory (rmem) binding
nvmem: add support for nvmem-cells binding
sandbox: use nvmem on top of stickypage for reset reason
power: reset: port Linux generic NVMEM reboot mode driver
sandbox: use nvmem-reboot-mode instead of syscon-reboot-mode
sandbox: dts: fix unit-address for state partition
nvmem: add command to list nvmem devices
sandbox: hostfile: move initcall to earlier postcore level
commands: md: don't leak heap memory with unaligned accesses
clocksource: RISC-V: demote probe success messages to debug level
RISC-V: virt: select only one timer
RISC-V: extend multi-image to support both S- and M-Mode
RISC-V: cpuinfo: return some output for non-SBI systems as well
of: of_net: sync of_get_mac_address with Linux for NVMEM support
net: consult device tree for ethernet address in NVMEM as fall-back
RISC-V: S-Mode: propagate Hart ID
RISC-V: erizo: make it easier to reuse ns16550 debug_ll
RISC-V: socs: add Kconfig entry for StarFive JH7100
nvmem: add StarFive OTP support
RISC-V: dma: support multiple dma_alloc_coherent backends
RISC-V: add exception support
RISC-V: support incoherent I-Cache
drivers: soc: sifive: add basic L2 cache controller driver
soc: starfive: add support for JH7100 incoherent interconnect
soc: sifive: l2_cache: enable maximum available cache ways
net: designware: fix non-1:1 mapped 64-bit systems
net: designware: add support for IP integrated into StarFive SoC
mci: allocate DMA-able memory
mci: allocate sector_buf on demand
dma: allocate 32-byte aligned buffers by default
mci: dw_mmc: add optional reset line
mci: dw_mmc: match against StarFive MMC compatibles
clk: add initial StarFive clock support
reset: add StarFive reset controller driver
watchdog: add StarFive watchdog driver
hw_random: add driver for RNG on StarFive SoC
reset: add device_reset_all helper
gpio: add support for StarFive GPIO controller
misc: add power sequencing driver for initializing StarFive peripherals
RISC-V: StarFive: add board support for BeagleV Starlight
reset: stm32: remove implicit sizeof(long) == 4 expectation
input: virtio: poll from poller, not bthread
bthread: add debug print for scheduler context switches
common: move workqueue handling from poller_call() to sched()
common: bthread: schedule only in command context
bthread: implement basic Linux-like completion API
Documentation: devel: background-execution: update bthread docs
usbgadget: refactor usbgadget_register to accept array
usbgadget: add support for USB mass storage gadget
spi: imx: enable use for i.MX8MM and i.MX8MP
bthread: remove thread exit codes
bthread: replace blocking bthread_stop with nonblocking bthread_cancel
bthread: add options to create and delete dummy bthreads
string: implement strchrnul
console: respect baudrate specified in device-tree stdout-path
test: self: add tests for progress notifier
nvmem: fix dev_dbg(unregistered_device, ...)
driver: add CONFIG_DEBUG_PROBES
pinctrl: stm32: support deep probe
ARM: imx6: marsboard: simplify ar8035 PHY fixups
ARM: imx6: marsboard: enable deep-probe
OF: gpio: drop duplicate of_device_ensure_probed
sandbox: ship sample environment
sandbox: power: set $global.system.reset=POR on poweroff
sandbox: fix probe order dependency between watchdog and power
of: partition: implement of_partition_ensure_probed
state: support deep probe
nvmem: support deep probe
sandbox: turn into deep probe platform
Revert "sandbox: hostfile: move initcall to earlier postcore level"
ARM: at91: fix building samad2 images without sama5d3
Antony Pavlov (3):
RISC-V: make it possible to run nmon from PBL C code
RISC-V: boards: erizo: make it possible to use nmon
RISC-V: boards: beaglev: make it possible to use nmon
Geert Uytterhoeven (1):
clk: starfive-jh7100: Fix duplicate numbers
Lucas Stach (1):
of: base: move memory init from DT to initcall
Marco Felsch (9):
imx53: remove unused imx53_add_nand
of: platform: remove check of already added devices
of: platform: Keep track of populated platform devices
of: base: move clock init from of_probe() to barebox_register_of()
initcall: add of_populate_initcall
common: add initial barebox deep-probe support
ARM: i.MX: esdctl: add deep-probe support
ARM: stm32mp: ddrctrl: add deep-probe support
ARM: boards: mx6-sabrelite: add deep-probe support
Michael Riesch (2):
aiodev: add driver for Rockchip SARADC
arm: rk3568-evb1: add support for Rockchip SARADC
Michael Tretter (7):
ARM: zynqmp: set reset source
clk: zynqmp: do not enable already enabled clocks
dts: zcu104: add Barebox environment
ARM: zynqmp: add update handler
ARM: zynqmp: zcu104: register update handler
ARM: zynqmp: defconfig: enable more features
Documentation: zynqmp: add some documentation
Rouven Czerwinski (5):
usb: usb251xb: remove >=0 check for u32 port
common: bbu: only add available handlers
common: bbu: add pr_fmt
image-sparse: remove unused define
mci: imx-esdhc-pbl: initialize fsl_esdhc_host
Sascha Hauer (79):
regulator: fixed: Use gpiod
usb: storage: Improve message
usb: ehci: Fix unitialized variable
clk: fix of clk set defaults when dev is a clk provider
ARM: mmu: inherit pte flags from pmd
clk: Add clk_name_* functions
clk: rockchip rk3568: Initialize clocks
filetype: Add Rockchip boot image type
ARM: Rockchip: Add rkimage tool
ARM: Add relocate_to_adr_full()
ARM: Rockchip: Add rk3568 dtsi files
filetype: Add function to check if a filetype is a compressed file
arm64: bootm: Add dryrun check
riscv: bootm: Add dryrun check
libfile: Add copy_fd()
ARM: Add atf common support
of: of_copy_node(): Copy phandles as well
of: Add function to duplicate a device tree
fdt: Check blob size during unflattening
firmware: make device_node argument non const
libbb: Add find_path function
firmware: consolidate ifdefs
firmware: Add search path
firmware: Fix device_node matching
firmware: recognize by reproducible name
blspec: Set firmware searchpath
overlay: Add of_overlay_apply_file()
firmware: Load from global search path
of: Set of_chosen and of_model earlier
of: implement of_get_stdoutpath()
pinctrl: Find controller node first
common: Explicitly probe consoles earlier with deep probe
pinctrl: Add deep probe support
phy: Add deep probe support
ARM: i.MX Phytec physom: convert to board driver
ARM: i.MX Phytec physom: Add deep-probe support
of: Add dummy driver
of: refuse to delete root node of live tree
of: Fix deep-probe triggering when removing nodes
ARM: Rockchip: Add rk3568 support
ARM: rockchip: Add bootm handler for RKNS images
ARM: Rockchip: Add rk3568 evb board support
Add rockchip_v8_defconfig
clk: rockchip rk3568: Register softrst handler
usb: ehci: Handle clocks and phys
phy: Rockchip: Add driver for usb2phy
phy: rockchip: Add naneng-combphy support
ARM: Rockchip: rk3568: Add USB nodes
ARM: Rockchip: rk3568 EVB: Add USB support
ARM64: Implement mem*_*io()
usb: dwc3: Use _io functions on dma coherent memory
ARM: Rockchip: rk3568 EVB: Add eMMC pinmux
pinctrl: rockchip: Register gpios as device
ARM: rockchip_v8_defconfig Disable ARC_EMAC driver
blspec: Rework firmware load
overlay: Add filters to choose which overlays to apply
blspec: Apply overlays from rootfs
doc: devicetree: Refer to internal device tree also as live tree
Documentation: Add documentation for device tree overlays
of_firmware: Fix handling of firmware-name property
dts: update to v5.13-rc6
dts: update to v5.13-rc7
Merge branch 'for-next/arm'
Merge branch 'for-next/clk'
Merge branch 'for-next/deep-probe'
Merge branch 'for-next/dts'
Merge branch 'for-next/firmware'
Merge branch 'for-next/misc'
Merge branch 'for-next/nvmem'
Merge branch 'for-next/riscv'
Merge branch 'for-next/rockchip'
Merge branch 'for-next/usb'
Merge branch 'for-next/usb-gadget'
Merge branch 'for-next/zynqmp'
crypto: add crypto_memneq()
crypto: digest: use crypto_memneq()
password: Use crypto_memneq() to compare hashes
fit: Use digest_verify() to verify hashes
Release v2021.08.0
Steffen Trumtrar (9):
reset: add of_reset_control_get to header
drivers: add fpga bridge framework
drivers: fpga: add socfpga bridges
firmware: socfpga: change function prefixes
firmware: import fpga-mgr.h from linux
of: kconfig: of_overlay uses firmwaremgr_load_file
drivers: firmware: socfpga: remove bridges shutdown
firmware: add support for compressed images
firmware: socfpga: set APPLYCFG after loading bitstream
Uwe Kleine-König (1):
w1: Replace license and copyright boilerplate by SPDX identifiers
Yunus Bas (1):
commands: of_property: Extend command usage on external dtb
--
Pengutronix e.K. | |
Steuerwalder Str. 21 | http://www.pengutronix.de/ |
31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2021-08-23 14:29 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2021-08-23 14:27 v2021.08.0 Sascha Hauer
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox